We recently upgraded to version 2017 and have run into an issue with the way circles that are measured less than 360 degrees report out. We have a Zeiss CMM and generate DMO files to make our reports, so when we measure a circle say from 180 to 360 degrees the new software reports this as an arc instead of a circle like 2016. The only way I know to fix the reporting issue is to go into each program, determine which holes are measured as a semi circle and construct a circle that can be reported out. This would entail checking upwards of 150 programs and thousands of circles. Is there another fix to this issue anyone is famialiar with?
