I have come across an issue I have never seen before. I picked up my tooling balls and start running the full layout. The surface points run just fine but when it gets to the trim + Hole features the program faults out.
I then have to F9 every point or right click on the feature and go into Feature -- > Reset measured values to nominal for the points to run.
Is there a setting that I have off for the program to behave this way? Once I run through the program once it runs fine.
I feel like it's something so simple causing this but can't figure out why.
Is this Analog probing? Scanning? Vision? What version of PCD? What machine? Does the name of the feature have spaces, math symbols in it? Is it named "Trim + Hole? no math symbols allowed.
Is this Analog probing? Scanning? Vision? What version of PCD? What machine? Does the name of the feature have spaces, math symbols in it? Is it named "Trim + Hole? no math symbols allowed.