Has anyone seen a FCF like this? Was wondering if it is a universal thing or if it's customer specific. I think I might understand what it's asking, but I'm not sure how to input that into PC DMIS. A and B in the FCF are points on either end of a tube.
They are not calling out straightness, they are asking you to measure the position of the Datum A tube at the 5mm zone against the centerline formed between A and B. Since the tube is a reference with no tolerance, just omit the MMB from A and B, and the MMC from the 3 tolerance.
Is there any standard references on the print? Your best bet is to go back to the customer and ask for clarification, in writing.
They are not calling out straightness, they are asking you to measure the position of the Datum A tube at the 5mm zone against the centerline formed between A and B. Since the tube is a reference with no tolerance, just omit the MMB from A and B, and the MMC from the 3 tolerance.
Is there any standard references on the print? Your best bet is to go back to the customer and ask for clarification, in writing.