Has anyone seen a FCF like this? Was wondering if it is a universal thing or if it's customer specific. I think I might understand what it's asking, but I'm not sure how to input that into PC DMIS. A and B in the FCF are points on either end of a tube.
That's what I did, I measured the position of that 5mm length to the axis of the entire tube. My boss told me to use the stock tolerance from another similar tube. I don't know how to build that FCF in PC DMIS, so I assigned that axis from A-B as Datum A with a comment that it represents A-B on the print. See below. I didn't know how else to do it. My first PPAP and it had to be a print that I don't really understand .
That's what I did, I measured the position of that 5mm length to the axis of the entire tube. My boss told me to use the stock tolerance from another similar tube. I don't know how to build that FCF in PC DMIS, so I assigned that axis from A-B as Datum A with a comment that it represents A-B on the print. See below. I didn't know how else to do it. My first PPAP and it had to be a print that I don't really understand .
.
