I have used the clearance cube function with most of the programs I have written when I download a CAD file. Occasionally they don't work. The cube is activated, it is displayed on the graphic window and the probe paths seem to avoid it when run in offline mode, When I run the program online the probe tries to take the shortest distance through the part. Any ideas? I have tried re-writing the program and got the same result. I cant post my code here because our security protocols do not allow the CMM to be connected to our network because of the administrator privilege required to run PCDMIS.
Thanks NinjaBadger. So in my 2023.1 release, I can check the CC status for a feature but I cannot retroactively activate it if I created the feature without CC active? If so, that does seem like a software change that is not so good.
Glenn
You can retroactively activate it, but only on a feature by feature basis.
Thanks NinjaBadger. So in my 2023.1 release, I can check the CC status for a feature but I cannot retroactively activate it if I created the feature without CC active? If so, that does seem like a software change that is not so good.
Glenn
You can retroactively activate it, but only on a feature by feature basis.
