I have to measure a 1-72 thread location. I want to do this by putting a 1-72 Go Member in the threaded hole and this measure it. I know how to reverse the inspection direction and to move the location of the points to be inspected.
I need to create a manual pause in my inspection program so an operator can insert the Go Member. I also want to add a line statement to direct the operator to insert the Go Member. I have version 2022.2. How can I do this?
Same as above. Operator comment is easiest way.. But don't forget to add a couple of move points before and after to get the probe out of the operators way so they can put the insert in, and then after the comment, back in line to the hole.
Same as above. Operator comment is easiest way.. But don't forget to add a couple of move points before and after to get the probe out of the operators way so they can put the insert in, and then after the comment, back in line to the hole.