I have to measure a 1-72 thread location. I want to do this by putting a 1-72 Go Member in the threaded hole and this measure it. I know how to reverse the inspection direction and to move the location of the points to be inspected.
I need to create a manual pause in my inspection program so an operator can insert the Go Member. I also want to add a line statement to direct the operator to insert the Go Member. I have version 2022.2. How can I do this?
These are all great suggestions. I've been programing in PC Dims for a week (and doing quite well). If this was Zone3 or Calipso I would know which pull down menus to do this operation in. Can someone post which pull down menu the "Operator Comment" is in?
These are all great suggestions. I've been programing in PC Dims for a week (and doing quite well). If this was Zone3 or Calipso I would know which pull down menus to do this operation in. Can someone post which pull down menu the "Operator Comment" is in?
Stop thinking like you're in collapse-o. Change screen from summary mode to "Command Mode", then be a real programmer and just type it in.
INSERT -TAB-
OPER -TAB-
YES (fullscreen) -TAB-
NO (autocontinue) -TAB-
"Please install plug gage into 1-72 threaded hole." -ENTER-
"Press OKAY ONLY when plug is in place & CMM is clear"
Voila, no dropdown or even a mouse-click needed, aside from getting to the cursor location in the code.
PCDMIS is way better than collapse-o any day because of this one single trait.