Thanks for reading. Had a quick inquiry as to why one of my distance dimensions are goofy and was hoping maybe someone could provide some insight.
I'm measuring two distances in the same workplane. A 14 inch distance as well as a 10 inch distance. The 14 inch dimension coincides with an indicator on a height gage within .0002". However, on the 10 inch dimension, the CMM gets it undersized, but when checking with the indicator its actually a few tenths above nominal.
The CMM readout vs the height stand with indicator on this dimension is a difference of .023". Anyway, I could possibly tighten this up? Thanks again for your time.
what about how you are solving for that plane, math type? Use Profile to dimension and see if that is better. Unless you have figured it out of course.
what about how you are solving for that plane, math type? Use Profile to dimension and see if that is better. Unless you have figured it out of course.