Constructed 3D line Populating Far From Edge

Lukas 11 months ago

Good morning,

Please see attached image. I created a 3D line based on the intersection of two planes: the top plane and the small side plane. When I run the program, I noticed the line that constructs is very far away from the small planes. I believe this will result in great measurement error (extrapolation). Can someone please explain how to make the line construct in the right place?

Thank you

Attached Files

Matthew D. Hoedeman 11 months ago

try reversing the plane selection order.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Lukas 11 months ago

try reversing the plane selection order.

That'll do it. It's still not quite centered, but it's good enough for this program. I could probably alter my Y-value on the constructed line to center it more, right?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Matthew D. Hoedeman 11 months ago in reply to Lukas

Reversing pick order has 'fixed' a few issues in Pcdmis in the past, that is why I suggested it, I don't use constructed 'anything' very often.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN 11 months ago

Can you post the code, even if the issue is fixed ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel