Can someone explain how I can create an MMC from opposing points? There is not enough area on the feature to measure a line or plane. It is an outside feature (extruded tab). Thanks
Then measure the slot as a slot. If you need two different position dimensions, simply dimension the measure slot as one (with 1 axis) using the width then construct a circle using the THEO and ACT of the measured slot, but use the length for the diameter, then dimension that hole.
Then measure the slot as a slot. If you need two different position dimensions, simply dimension the measure slot as one (with 1 axis) using the width then construct a circle using the THEO and ACT of the measured slot, but use the length for the diameter, then dimension that hole.
