Help needed on coordinate system upside down

Hello all.

Finally, I made a program for the wire, which used manual hits on a cylinder and a circle. After alignment, I found all X Y Z were upside down. really headache. Thank you for any help

Parents

RobOntario over 1 year ago

Why are your theo/actual vectors so different? By about 90 degrees?

This was the start I had the issue. After rotated X axis 180 degrees. The issue was gone.

Thank you all for all the helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

RobOntario over 1 year ago

Why are your theo/actual vectors so different? By about 90 degrees?

This was the start I had the issue. After rotated X axis 180 degrees. The issue was gone.

Thank you all for all the helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data