Thermal Comp on report

Is there a way to show the thermal compensation ON on the CMM report? Please advise how it is achieved if so. One of our customers is requiring it in their standards.

Parents

WilliamL over 1 year ago

TEMPCOMP/METHOD = AUTOMATIC,MATERIAL = Copper,CTE=17
              ,SET WARNING LIMIT = FALSE,MINIMUM = 10,MAXIMUM = 40
              ,PART SENSOR NUM=DEFAULT,X SCALE= 20,Y SCALE= 20,Z SCALE= 20,PART TEMP=20
            ASSIGN/V1=GETCOMMAND("Temperature Compensation", "TOP", 1)
            ASSIGN/V2=GETTEXT("TEMPP", 0 , V1)
            ASSIGN/V3=GETTEXT("MATERIAL", 0 , V1)
            ASSIGN/V4=GETTEXT("MATERIAL_COEFFICIENT", 0 , V1)
            ASSIGN/V5=GETTEXT("X SCALE", 0 , V1)
            ASSIGN/V6=GETTEXT("Y SCALE", 0 , V1)
            ASSIGN/V7=GETTEXT("Z SCALE", 0 , V1)
            COMMENT/REPT,
            "Part Temp : "+V2
            "Material Type : "+V3
            "Material Coefficient : "+V4
            "Current Scale Temperatures : X=" +V5+ " Y=" +V6+ " Z=" +V7

I did it here through assign statements.

This is also in offline mode.

Attached Files

Reply

WilliamL over 1 year ago

TEMPCOMP/METHOD = AUTOMATIC,MATERIAL = Copper,CTE=17
              ,SET WARNING LIMIT = FALSE,MINIMUM = 10,MAXIMUM = 40
              ,PART SENSOR NUM=DEFAULT,X SCALE= 20,Y SCALE= 20,Z SCALE= 20,PART TEMP=20
            ASSIGN/V1=GETCOMMAND("Temperature Compensation", "TOP", 1)
            ASSIGN/V2=GETTEXT("TEMPP", 0 , V1)
            ASSIGN/V3=GETTEXT("MATERIAL", 0 , V1)
            ASSIGN/V4=GETTEXT("MATERIAL_COEFFICIENT", 0 , V1)
            ASSIGN/V5=GETTEXT("X SCALE", 0 , V1)
            ASSIGN/V6=GETTEXT("Y SCALE", 0 , V1)
            ASSIGN/V7=GETTEXT("Z SCALE", 0 , V1)
            COMMENT/REPT,
            "Part Temp : "+V2
            "Material Type : "+V3
            "Material Coefficient : "+V4
            "Current Scale Temperatures : X=" +V5+ " Y=" +V6+ " Z=" +V7

I did it here through assign statements.

This is also in offline mode.

Attached Files

Children

No Data