PC-DMIS 2023 and position of a plane to 3 datums

Question

Hi folks 
 1st time on the new forum.... takes a bit of getting used to. 
 I'm just trying to get to grips with 2023 version and the part I'm measuring has an FCF Position callout from a plane face back to 3 datums. 2023 doesn't appear to offer that option anymore, as when I open the position dialogue box, the plane I need to dimension is not there to select. 
 Any thoughts on how I might get round this please? 
 Cheers

Neil Challinor · Accepted Answer

Position of a plane is only valid under ISO 1101. ASME Y14.5 only allows position for features of size so, as John Loftus said, you would need to use profile of a surface instead. If your drawing references ASME Y14.5 and shows position of a plane then it is incorrect.