Good Morning,
Just installed a new probe rack to a CMM that used to have a probe rack. This is the HR-MP6 for touch trigger probes. I calibrated my master tip and then calibrated the rack. Assigned probes to slots and the ran a test probe that cycled the probes in and out of the slots.
The only issue I have is that when the CMM drops off a probe and goes to load the next one, Its too high and tries to go through the lid to grab the probe. I pushed all the lids back and cycled through the probes and no issues. Obviously I want the lids closed. I installed of these racks before on another CMM and I didn't' have this issue then.
Does anyone else have any ideas?
Thanks.
