[2023.2 SP3] Smartcalculation for cylinder not enabled?

Like title.

Doing autocylinder, I don't have the (Smartcalculation) text next to the end dimension (where the last level of hits are taken).
Do I need to enable something in order to enjoy this new feature?

0 Neil Challinor 10 months ago

What environment are you running and what type of probe do you have active?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 vpt.se 10 months ago in reply to Neil Challinor

Active sensor is a HP-S-X1H with a Ø3 length 50.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Neil Challinor 10 months ago in reply to vpt.se

Have you tried doing a "Reset User" from the settings editor?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 vpt.se 10 months ago in reply to Neil Challinor

No, I haven't. What kind of havoc would that cause me? User settings like window layout, colors etc will be nuked? Any hardware settings that goes out the window?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Neil Challinor 10 months ago in reply to vpt.se

A reset user should not affect hardware settings, just user specific settings like windows layout as you mentioned. Make a backup of your settings before trying and then you can always re-import them if the reset user doesn't help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 vpt.se 10 months ago in reply to Neil Challinor

UPDATE: The (SmartCalculation) label is visible when choosing autocylinder with lines, but not when choosing autocylinder concentric circles (but it seems that it is in effect anyway, looking at the value).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel