Controller Lost Home Position

Pc-Dmis 2023.2 crashed while using Global 07.10.07 resulting in 200mm shift in the Home position!! machine is now inoperable as it stands. Is there a way to reset this home position or will I need to get Support to look into it??

Parents

0 Wakkadder 10 months ago

Software crashed and the Light on the Jogbox went out , but would not reactivate until I restarted the Controller, that is when I noticed the Shift in Home Position
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Neil Challinor 10 months ago in reply to Wakkadder

Have you tried driving the machine close to the original home position (within about 50mm - be careful not to run into the hard stops) and then shutting everything down (PC-DMIS and controller) before restarting? It may just be that the homing cycle is detecting the wrong mark on the scale.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Neil Challinor 10 months ago in reply to Wakkadder

Have you tried driving the machine close to the original home position (within about 50mm - be careful not to run into the hard stops) and then shutting everything down (PC-DMIS and controller) before restarting? It may just be that the homing cycle is detecting the wrong mark on the scale.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data