Good Morning.
This morning when I started a new program, I found the round slot checking pattern was changed for 10 hits, the find hole 6 hits check was normal, but it did not verify the width in 10 hits , only on 2 arcs( Please check the attached image for measured points). I never met this kind of issue before, How to fix it?
Is it possible that the issue came from Cad which we use .stp files?
Thank you
My is v2015.1
In my memory, I have this kind of pattern for round slot.
Looks like a toggle option isn't clicked in your first picture. I am not familiar with this interface.
In Auto Feature mode, when I clicked an other round slot, it could be picked, but those 2 round slots did not work this way, this might come from the cad model, I think.
I
Looks like a toggle option isn't clicked in your first picture. I am not familiar with this interface.
That toggles the path lines on/off. Normally, turning that off would mean that you wouldn't be able to see where the hits were going to be taken. However, he has "show measured points" selected so the green dots represent hits that were recorded the last time the feature was measured.
Thank you, Neil. It is Okay now.
