Thanks for reading.
I'm having an issue with a part I'm trying to draft a pgm for. The photo above shows Datum B which is a hinge. I cannot measure this hinge with a probe. I just can't get to it. So, I place a pin in the hinge and create a measured cylinder off the pin. When I execute the program i does not measure the cylinder properly. Further more the cylinder isn't facing the right orientation. I'm kind of lost. Any ideas? Thanks
Thanks for all the insight everyone. I appreciate it greatly. I am still having a few issues however. I have attached a partial of my print and the cylinder issue I'm still having.
louisd I did your suggestion. I made two circles in the YPlus plane. They looked fine. I then constructed a cylinder out of those two circles and the same thing happened from the first.
I attached another doc, this time with excerpts of the print I'm working off of. I can reveal more print if need be.
Datum A is the part underside, Datum B seems to be the hinge centerpoint and Datum C Is a line? Maybe I have this aligned like garbage?
I appreciate everyones help and insight. Thanks
DOCX
