Cloud Point Operator "CLEAN". Is this a Global feature and who's value carries over to the next program automatically.

Clean is an Operator that runs with each execution, and is calculated based on your current data. Once a COP is ran through the CLEAN Operator, that data then continues downward. The amount "cleaned" does not carry over per run, but is calculated each run when it gets to that line of code.

Clean is an Operator that runs with each execution, and is calculated based on your current data. Once a COP is ran through the CLEAN Operator, that data then continues downward. The amount "cleaned" does not carry over per run, but is calculated each run when it gets to that line of code.

So that also applies to a different part and program....should have no effect from the previous program......correct???

Thanks

Correct. The clean COP only affects the COP it has a Reference to in the program.

COPCLEAN1 has a reference to COP1, which is in the current program.

COP1       =COP/DATA,TOTAL SIZE=3,REDUCED SIZE=3,
            FINDNOMS=NO,REF=SCN4,,
COPCLEAN1  =COP/OPER,CLEAN,MAX DISTANCE=0.04,APPLY MAX ANGLE=NO,
            SIZE=0,REF=COP1,,

Make sure you properly place Cloudpoint Empty and Purges where needed. I was told to put purges at the end of the program, but I personally did it at the beginning instead in case I want to look back at my data after a program has ran. I haven't used my HP-L-10.10 in months though, and am a bit rusty on Cloudpoint operators.