About Xact, why FCFPROF1 PLN2 failed?

Hello all.

I checked one report found something suspicious, I think PLN2 should pass, but it was red and failed, but why? I am not good at Xact, anyone could explain to me? Thank you

Parents

0 WilliamL 10 months ago

My guess is a trailing decimal / rounding deviation. Try expanding your display precision to 7, and see if there is any trailing decimals. It may have measured .3580001
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 WilliamL 10 months ago

My guess is a trailing decimal / rounding deviation. Try expanding your display precision to 7, and see if there is any trailing decimals. It may have measured .3580001
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 RobOntario 10 months ago in reply to WilliamL

Is this ? Where to expand display precision to 7?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 WilliamL 10 months ago in reply to RobOntario

Yes, but you can also just start typing displayprecision in the edit window, and change it from there.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 RobOntario 10 months ago in reply to WilliamL

Got it. Everyday get something new . Thanks
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 WilliamL 10 months ago in reply to RobOntario

No problem. It works similarly to a clearplane command. The displayprecision works for everything below it until the next displayprecision command. So you can have the early parts of your program set at displayprecision 7 to get everything fine tuned. Then add one further down for reporting, or even before that. It's quite useful
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel