I've had to create a long probe (added a 70mm extension to an existing probe).
I need to add an angle change to it (A15B180). but when I go to calibrate them together, when it makes the angle change, the height looks right, but the probe is off several inches in "Y". Even if i use the long tip as a "master", when it kicks up on the A15, it has to be off two or three inches (in +Y).
I've checked the probe builds and they are identical. I've checked the probe builds back to existing probes that calibrate multiple angles fine and the only difference is the 70mm extension.
I don't know if there is a setup file somewhere that has to be put in a folder that was created when the probe tip was created or what. Any input would be greatly appreciated.
