I am having an issue with my dual arm set up measuring a couple points on Arm 2. These points are on the roof of a car and would fall on a center line down the middle of the roof. It is a simple subroutine where Arm 2 measures 8 points down the middle of the roof starting from front and working back. Arm 2 is able to measure most of the points, but as it approaches the back I get "TR_OUTOL, Machine Parameter out of tolerance" for remaining few points and move steps. Both arms also take points at the back of the roof (that aren't in middle) with the same probe tip and has no issues nor does any other probe tip in other subroutines. These other points and move steps fall close to the ones that are "out of tolerance" on the routine causing issues.
What are some things I should try to fix it? I loaded an old back up and all the move steps and measure points were the same values and got the same result.
