2019R2

WE have 2 versions of PC-DMIS on the same machine. (2019R and 2023.1)

Open a program (any) in 2023, (converted over from 2019) it performs as expected.

Open a program in 2019, and it loads the probe and rest of the startup commands, then stops advancing.

This is as far as it gets.

STARTUP    =ALIGNMENT/START,RECALL:USE_PART_SETUP,LIST=YES
            ALIGNMENT/END
            PREHIT/0.5
            RETRACT/0.5
            DISPLAYPRECISION/6
            MOVESPEED/ 100
            TOUCHSPEED/ 1.5
            FLY/ON
            PROBECOM/ON
            RMEAS/LEGACY (I,J,K, X,Y,Z)
            FORMAT/TEXT,OPTIONS, ,HEADINGS,SYMBOLS, ;NOM,MEAS,TOL,DEV,OUTTOL, , 
            LOADPROBE/3_TP20_15 X 20 + 1CM
            TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            DISPLAYPRECISION/4

0 WilliamL 6 months ago

Change the name of your probe to something that does not have spaces or a mathematical symbol in it, like 3_TP20_15X20_PLUS1CM or just 1CM. It may be trying to read that as an equation. I am not entirely sure if that would halt your program though as I've never named any probes or features like this. See if that changes anything.
Cancel
Vote Up +3 Vote Down

Sign in to reply

Verify Answer

Cancel