Remeasure issue.

Hello all

I had a program issue today. Since there were some variations, so I used the remeasure function. After the first round checked, the probe crashed on the pin, not reverse the first round movements which I learned from the help. Anything wrong with setting, or I missed something.

Thank you , Have a good weekend.

Parents

0 Matthew D. Hoedeman 6 months ago

turn on avoidance moves, both, then it should work.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 WilliamL 6 months ago in reply to Matthew D. Hoedeman

Yeah, this should be the solution. I know when I've used remeasure in the past after it takes the last hit of a feature it immediately goes back to take sample hits I believe without using the clearplane. Avoidance moves have worked for me.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 WilliamL 6 months ago in reply to Matthew D. Hoedeman

Yeah, this should be the solution. I know when I've used remeasure in the past after it takes the last hit of a feature it immediately goes back to take sample hits I believe without using the clearplane. Avoidance moves have worked for me.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 RobOntario 6 months ago in reply to WilliamL

Yes, your guys are right. Should turn on avoidance moves. Only if avoidance is off, for outer features, it might work sequently in reverse to prevent collisions
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel