for context, i have measured 50 workpieces multiple times and after tabulating my data realised that I was getting different readings when using a 1mm or 3mm diameter probe. Only now do I realise that I should have set one of them (the 1mm dia probe) as the primary probe, and the 3mm as the secondary tip. I have learnt how to do this. Only problem is that I have all the previously wrongly measured workpieces using the old calibration data (where both 1mm and 3mm were separately calibrated as "primary" probe accidentally). Would it be possible to transfer this new probe calibration data to the old measurement routines to get new coordinates? Or is it necessary for me to re-program and re-measure all my parts again?
