un-even profile tolerance

I have an un-even profiile tolerance, the callout is profile\.021\A. BUT, its .013 above the nominal surface, so basically, +.013 / -.008. How do we tell PCDMIS this uneven tolerance. I'm guessing, the report normally would say +.0105 / -.0105 ...change those to .013 / -.008? If I can?

Parents

0 Slipper57 Mills 9 months ago

Yes...I cannot figure out how to change it from +/- .0105 to +.013/ -.008.... I could alway just figure out the nominal at +.013 & -.008.... crazy. I have seen tolerances like this before though.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 WilliamL 9 months ago in reply to Slipper57 Mills

What version of PC-DMIS are you using? If you are using GeoTolerance in version 2020 R2 and above, there is this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Slipper57 Mills 9 months ago in reply to WilliamL

2014....sry... meant to state this earlier
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Slipper57 Mills 9 months ago in reply to WilliamL

2014....sry... meant to state this earlier
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data