non symmetric dimensioning

I cant seem to figure out how to make non symmetric tolerances on PC-DMIS, something like 110mm -0.05/-0.1 tolerance. It'll only let me do a positive/negative tolerance like 110 +0.05/-0.1. A temporary solution ive found is to just put the nominal somewhere in the middle of the tolerance but it doesnt seem like a great permanent solution. Does anyone know how to do it better?

Parents

0 Matthew D. Hoedeman 6 months ago

For -0.05/-0.10, enter NEGATIVE 0.05 ( -0.05 ) in for the positive tolerance and 0.10 for the negative tolerance.

for +0.10/+0.05, enter 0.10 for the positive tolerance and NEGATIVE ( -0.05 ) for the negative tolerance.

Pcdmis ASSumes a positive value for the positive tolerance and a negative value for the negative tolerance. So, you just have to add the NEGATIVE ( - ) along with the tolerance value and Pcdmis figures it out.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Matthew D. Hoedeman 6 months ago

For -0.05/-0.10, enter NEGATIVE 0.05 ( -0.05 ) in for the positive tolerance and 0.10 for the negative tolerance.

for +0.10/+0.05, enter 0.10 for the positive tolerance and NEGATIVE ( -0.05 ) for the negative tolerance.

Pcdmis ASSumes a positive value for the positive tolerance and a negative value for the negative tolerance. So, you just have to add the NEGATIVE ( - ) along with the tolerance value and Pcdmis figures it out.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data