Y-Axis stroke limit error on 2024.1 but not 2023.1

Question

Hi All, 
 I recently upgraded our software (offline and online seats) to 2024.1, and now several programs are having this error when doing a probe change specifically. 
 It's not every probe and it's not every angle, but when it does happen the probe has been picked up from the rack and then it gives me the error below and is unable to proceed with the angle change (TIP/ command). 
 
 Two things of note: 1. If I stop the execution, place the cursor at the "tip/" command and use CTRL+U, the program will continue without issue, until the next run where it will error out again. 
 2. I shut off 2024.1, opened 2023.1 and ran the exact same program, and there was no error whatsoever. 
 
 This seems like some kind of boundary limit that was changed behind the scenes in 2024.1, but I wouldn't even know where to look to adjust that. Any ideas??

JFournier · Accepted Answer

For anyone else who comes across this issue, I found the solution that seems to have fixed it, for my CMM at least. 
 I was not aware of the clearance cube moves that were associated with the actual "tip command", so when I accidentally put my cursor on it and noticed it was there, I just deactivated it and the movement problem seems to have gone away.