Newby question. When I was using quick check feature not to long ago, checking the height of 2 plains, and then a couple of weeks later I went and used quick check on the legnth of a part and the dimension came back .236 larger than what it should have been( double checked the dimension with our shop certified caliper).
Sounds like a probe comp issue to me OR a work-plane / alignment issue. You can't just take hits on each end of a part and expect the correct distance-between-points value.
Sounds like a probe comp issue to me OR a work-plane / alignment issue. You can't just take hits on each end of a part and expect the correct distance-between-points value.