Newby question. When I was using quick check feature not to long ago, checking the height of 2 plains, and then a couple of weeks later I went and used quick check on the legnth of a part and the dimension came back .236 larger than what it should have been( double checked the dimension with our shop certified caliper).
You can also do the pull point, but they are a pain in the (posterior). For a pull point, you have to press and hold the measure button, and pull squarly away from the surface, then release the button. You have to do it within 1 second, or after one second, PCDmis asumes you're scanning, and then you just get a bunch of points in space, that you now have to delete. Sample hits and watch your angle of approach is best.
You can also do the pull point, but they are a pain in the (posterior). For a pull point, you have to press and hold the measure button, and pull squarly away from the surface, then release the button. You have to do it within 1 second, or after one second, PCDmis asumes you're scanning, and then you just get a bunch of points in space, that you now have to delete. Sample hits and watch your angle of approach is best.