New to Pc-Dmis, CMM and of course the Romer. The current probe body (5024SC-0237) and tip (6mm) was changed to a (3mm) tip using the same body. This ruby ball has broken (they don't bounce very well) and I want to put the (6mm) tip back onto the probe body. The problem is, I don't know what file to go back into and what needs to be changed. We had an engineer that set up the tip and he has left the company. This Romer has been a nightmare, my company decided to purchase this setup and not spring for any training (unless you count 3 days with a salesman). I am stuck with a instrument I know little about and being new to inspection (less than 2 years) has me at a loss. I appreciate anyone’s help and time.
Where do I find the standards for my arm? So after I click finish, the probe tip is cal'd? I was getting a Std Deviation of .025mm and max error of .035mm. This is calibrating the probe (6mm probe) on the bar at the smallest conical seat.
Where do I find the standards for my arm? So after I click finish, the probe tip is cal'd? I was getting a Std Deviation of .025mm and max error of .035mm. This is calibrating the probe (6mm probe) on the bar at the smallest conical seat.