I have pc-dimis 2010. I write a program and run it through as i write it.My measurement checks will be correct but then as i go along writing the program and running through the new measurements I lose data from other measurements.My nominals will change and it will run through the program and then tell me that some of the features did not measure .What am I doing wrong? Any ideas?
Post the questionable code?
Aren't you going to run through the whole program when done?
Perhaps the alignment is not so hot and allowing things to vary?
Why is this in PC-DMIS portable?
All your profile shows for machine is "Sheffield". Which Sheffield?
Post the questionable code?
Aren't you going to run through the whole program when done?
Perhaps the alignment is not so hot and allowing things to vary?
Why is this in PC-DMIS portable?
All your profile shows for machine is "Sheffield". Which Sheffield?