I have pc-dimis 2010. I write a program and run it through as i write it.My measurement checks will be correct but then as i go along writing the program and running through the new measurements I lose data from other measurements.My nominals will change and it will run through the program and then tell me that some of the features did not measure .What am I doing wrong? Any ideas?
I am holding the part in a fixture that locates it in the same place every time and also there is a manual alignment in the program .I had to delete some of the code in order to post it. The theos is part of what I don't understand, this part of the program ran correctly and I don't know what caused it to change.The measurements that say 0 now were correct before.
I have been told that PC-DIMIS 2010 has had some problems that have been corrected,where can I find these patches?
I am holding the part in a fixture that locates it in the same place every time and also there is a manual alignment in the program .I had to delete some of the code in order to post it. The theos is part of what I don't understand, this part of the program ran correctly and I don't know what caused it to change.The measurements that say 0 now were correct before.
I have been told that PC-DIMIS 2010 has had some problems that have been corrected,where can I find these patches?