Under V4.3, I generated programs using CAD++. I selected the points from the model, did my alignment and off I went. Funny thing was that PC-DMIS had put MODE/DCC at the beginning of the program. The results seemed to be quite accurate so I never gave it a second thought.
When I start that same program in V2010, it runs right down to the end of the program. It does not let me take any points. I marked and unmarked, to no avail. It just runs all the way to the end. Takes the nominals as points and outputs.
If I change to MODE/MANUAL, the arm lets me take points (however, now I have issues with how the probe gets comped). If I then change back to MODE/DCC, it runs all the way down again on its own.
Why would it do that? It never did that in V4.3. How can I stop this from happening in V2010?