alignment

Ok so I am trying to get familiar with pcdmis 4.3 without reading the massive manuals. My shop has had a 2.0 arm and this software for quite some time without really being used much at all. our programs are written for virtual dmis and in use with old arms that no one will even calibrate anymore.

I am currently stumped as to how to make the correct cordinate alignment. I am writing offline with only prints no cad. Using datum A plane a line constructed out of Db and DC . I want to referance x and y back to DB circle with a -27.45 rotation on the x.

Can anyone please walk me through this.

Thanks in advance,
Christopher

Parents

QC5717 over 13 years ago

Thanks for your time all back to the books it is when i can fit it in the work load. I do have alot of experiance with the much older software we use with our much older romer arms model 1036 and B&S bridge type machine. The 1036 arms are over due for calibration and cimcore wont calibrate them anymore i was told from the lead inspector.

Yet no one in the department has the desire to become proficiant with the newer arm and software, which seems to be a completely differant beast than out dated virtual dmis.

Once again thanks for taking the time to give your input to my situation.

Christopher
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

QC5717 over 13 years ago

Thanks for your time all back to the books it is when i can fit it in the work load. I do have alot of experiance with the much older software we use with our much older romer arms model 1036 and B&S bridge type machine. The 1036 arms are over due for calibration and cimcore wont calibrate them anymore i was told from the lead inspector.

Yet no one in the department has the desire to become proficiant with the newer arm and software, which seems to be a completely differant beast than out dated virtual dmis.

Once again thanks for taking the time to give your input to my situation.

Christopher
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data