I've noticed so far that while looking at the cad model in the graphics display window it shows all the points I have taken during the inspection. What I'd like to know is if it possible to display seperate point groups while hiding all other points so I can report where hits were taken while inspecting certain features using the screen capture command.
You SHOULD be able to do this by showing ONLY the ones you want, save the view, then recall the view.
HOWEVER, Pcdmis doesn't do this very well, it will (sometimes) show ALL even when you only had a few showing when you saved the view, and I've seen the RECALL saved view code crash programs.
You SHOULD be able to do this by showing ONLY the ones you want, save the view, then recall the view.
HOWEVER, Pcdmis doesn't do this very well, it will (sometimes) show ALL even when you only had a few showing when you saved the view, and I've seen the RECALL saved view code crash programs.
