Here is my situation: I build an offline program using pc-dmis with a Cad Model but when i run it everything goes fine till i get past the alignment process that merges the cad with the part.After alignment i have a 12 bolt hole pattern that rotates 30 degrees..when running the program it does not wait for me to measure the hole but instead rotates 30 degrees 12 times without me measuring, almost as if it was on automatic measure mode like on a Cmm.I am new to romer and pc-dmis but experienced in the Cmm world.The training i took at hexagon was really a waste of time and thier tech support does not answer any questions but instead tells me that they will forward question to someone else and i would get a call back.It has been over a week and 2 phone calls later and still no call.i just need help in gettijng over this hump...all replys are greatly appreciated
