Your Products have been synced, click here to refresh
I have not used our Romer ARM for some time and I am struggling just to start the alignment.
I noticed when I created the plane for the Z axis feature, the software is not compensating the stylus ball. 15mms. The zero point is not Zero when I tough the stylus to the part after aligning. Plus when I make a point on the plane on Z axis I am getting .26 reading instead of "0".
What am I doing wrong?
I have not used our Romer ARM for some time and I am struggling just to start the alignment.
I noticed when I created the plane for the Z axis feature, the software is not compensating the stylus ball. 15mms. The zero point is not Zero when I tough the stylus to the part after aligning. Plus when I make a point on the plane on Z axis I am getting .26 reading instead of "0".
What am I doing wrong?
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |