Anytime i try to program a single point circle PC-DIMIS gives me an error saying "Hit 1 out of range". I have tried programing with different probe diameters, planes, and workplanes, still get the same error every time. What am I doing wrong?
Any help would be much apprectiated.
PC-DIMIS CAD Version 2012 (Release)
32 Bit Build # 513/pcdimis2012 [jun 29 2012]
I've done it a few times with small holes where the probe fits in the hole. Usually these holes are on weird surfaces so I do three sample hits around the hole and then one hit for the hole.
Eric
Romer with 2011
I've done it a few times with small holes where the probe fits in the hole. Usually these holes are on weird surfaces so I do three sample hits around the hole and then one hit for the hole.
Eric
Romer with 2011