I have been tasked with setting up a Romer with existing software that currently runs a CMM. Software PC-DMIS V. 4.2 MR1. I have set the Romer up, calibrated it using its utility feature (not with PC-DMIS) and now I need to know how to get PC-DMIS to recognize that there is a Romer attached. The CMM attaches through COM port 1 but the Romer has a USB connection. Do I need to uninstall and reinstall? Or can I manipulate the current version to "know" that there is a Romer attached....? Any and all help is appreciated.....
One thing I can't seem to find is if when I reinstall with the Romer Portlock, will PC-DMIS auto recognize the Romer or will I have to go into config and tell it where to look? If I have to tell it where to look, all I have ever seen is COM ports, this Romer is USB and the comp isn't Bluetooth ready so that is off the table... Thanks!
1-install WinRDS or RDS dependig of your arm type (Cimcore / Romer)
2-load the latest armspecs data (calbration / compensation / error map etc)
3-install pcdmis
One thing I can't seem to find is if when I reinstall with the Romer Portlock, will PC-DMIS auto recognize the Romer or will I have to go into config and tell it where to look? If I have to tell it where to look, all I have ever seen is COM ports, this Romer is USB and the comp isn't Bluetooth ready so that is off the table... Thanks!
1-install WinRDS or RDS dependig of your arm type (Cimcore / Romer)
2-load the latest armspecs data (calbration / compensation / error map etc)
3-install pcdmis
