I have been tasked with setting up a Romer with existing software that currently runs a CMM. Software PC-DMIS V. 4.2 MR1. I have set the Romer up, calibrated it using its utility feature (not with PC-DMIS) and now I need to know how to get PC-DMIS to recognize that there is a Romer attached. The CMM attaches through COM port 1 but the Romer has a USB connection. Do I need to uninstall and reinstall? Or can I manipulate the current version to "know" that there is a Romer attached....? Any and all help is appreciated.....
In this new version you can not just copy the folders over manually you must follow this procedure.
1. Power the Arm off and insert the Armspecs Floppy disk.
2. Open the CimCore Arm Utilities short cut on your desktop.
3. Cancel the error message.
4. Select the Config button then the Armspecs Tab.
5. Point the 3 1/2 floppy drive or what ever location you have the
Armdata and
Armdata.s6x folders located.
* DO NOT SELECT THE ARMDATA FOLDER ONLY POINT TO THE LOCATION IT IS STORED IN. 6. Select OK once then select OK a second time for the
Armdata.S6X folder.
Once this is complete you can power the Arm on to connect.
In this new version you can not just copy the folders over manually you must follow this procedure.
1. Power the Arm off and insert the Armspecs Floppy disk.
2. Open the CimCore Arm Utilities short cut on your desktop.
3. Cancel the error message.
4. Select the Config button then the Armspecs Tab.
5. Point the 3 1/2 floppy drive or what ever location you have the
Armdata and
Armdata.s6x folders located.
* DO NOT SELECT THE ARMDATA FOLDER ONLY POINT TO THE LOCATION IT IS STORED IN. 6. Select OK once then select OK a second time for the
Armdata.S6X folder.
Once this is complete you can power the Arm on to connect.
