We recentely purchased a new version of PC-Dmis 2012 mr1. I've written a few part inspection programs and verified / ran them on different parts. I am seeing the nominals change every once in a while when I just run a program or more so when modify a program by adding a new dimension to the program. It doesn't seem to affect the new dimension, just random dimensions on the report which causes me to have change the nominal back and then refresh the report.
I experience this to a greater occurance when I run programs that I had created using 2010 MR1.
The 2012 MR1 program was installed on a brand new laptop.
I was told that 2010 MR1 had some memory leaks and that was the cause of the nominals changing. Does 2012 have the same issues too? ( we upgraded to get rid of the nuissance of having to shut down and restart every 10 -15 minutes of use on the old system )
I am two having the same problem lately, I have been creating new programs with 2012 mr1 and yet my theoreticals are changing on me. so when I fix them back to being perfect it will throw my alignments off and cause me to all over. No clue why...good luck and let me know if you find out about anything.
I am two having the same problem lately, I have been creating new programs with 2012 mr1 and yet my theoreticals are changing on me. so when I fix them back to being perfect it will throw my alignments off and cause me to all over. No clue why...good luck and let me know if you find out about anything.