Execution arrow size.

Hi all. We just updated both of our Romer arms to 2013 MR1 and we've run into a slight problem.

During execution of a program, the red arrow that shows where the hit is to be taken is so small we can't see it. Is there any way to adjust the size of that arrow? On 2011 the arrows were plenty big, but we can't remember what we did to adjust the size of the arrows if we did at all.

Parents

thenev over 10 years ago

Sorry I forgot about that.

Go to the top of the your program in the edit window and put your cursor above where any of your first hits are. Press enter and type in prehit then add a value (.25). Press enter again and type retract then add the same value.

Hopefully that will increase the arrow size for you when you execute.

Unfortunately that didn't work either. It just changed the blue vector arrow while programming. Thanks for the suggestion though.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

thenev over 10 years ago

Sorry I forgot about that.

Go to the top of the your program in the edit window and put your cursor above where any of your first hits are. Press enter and type in prehit then add a value (.25). Press enter again and type retract then add the same value.

Hopefully that will increase the arrow size for you when you execute.

Unfortunately that didn't work either. It just changed the blue vector arrow while programming. Thanks for the suggestion though.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data