I check quite a few formed parts. I've ran into an issue a couple times now and I'm interested if the gurus have any answers, the problem goes as follows:
I setup a part on the table and begin inspection. I take a bunch of vector points that are on the surface of a formed angle (around 35 degrees) when I turn those vector points into a scan and assign it a profile of surface FCF the part is out of tolerance.
I wondered if when I convert the points to a scan if it assigns the scan a workplane and the worklplane caused issues but I tried the same experiment without putting the points into a scan to no avail. Additionally when I check the angles and bend lines the part seems to be right there for the basic dimensions.
what is the tolerance on the around 35 deg. formed angle? are you taking points on a surface that is out of tolerance? Also bend lines are reference dimensions only. The pressbrake operator can alter bend line dimensions to hold the final formed dimensions that are critical and are tolerance.
what is the tolerance on the around 35 deg. formed angle? are you taking points on a surface that is out of tolerance? Also bend lines are reference dimensions only. The pressbrake operator can alter bend line dimensions to hold the final formed dimensions that are critical and are tolerance.