Probe Comp

I created a PLN, Level to it, X- Orgin to it, when I create a PNT on that plane again it is showing exactly .060 instead of .000 The probe is a 3mm dia. Looks like some kind of probe comp issue.

apgar over 10 years ago

Look at thread titled Compensation Probe from a few days ago.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
WolfMan over 10 years ago

I did, it says that there is bug in v2013 but i have v2012.

If I measure a PLANE I get a close number but if I measure a point its .060" Large.

Please if anyone knows how to fix it let me know, it driving me insane!!

Is there anyone out there who can explain to me how this thing works???
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jleond over 10 years ago

I did, it says that there is bug in v2013 but i have v2012.

If I measure a PLANE I get a close number but if I measure a point its .060" Large.

Please if anyone knows how to fix it let me know, it driving me insane!!

Is there anyone out there who can explain to me how this thing works???

While not aligned yet to your part, make sure to use the "Pulled Hits Method" to take
measurements.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
WolfMan over 10 years ago

I explained in my first post that i did Level and Orgin on one saide if thr gage block.

Where do I find "pulled hits method"?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jleond over 10 years ago

I explained in my first post that i did Level and Orgin on one saide if thr gage block.

Where do I find "pulled hits method"?

Please read this: ftp://ftp.wilcoxassoc.com/docs/v2014manual/eng_pcdmis_2014_portable_manual.zip
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel