What would be the best way to inspect the dimension in the picture? It is from the point where the curved detail meets the plate down to where the curved detail meets the other flat surface. Is there an accurate way to find intersection points of the different details? It may be a little easier to check if there wasn't weld where each of these details come together.
Excuse my ignorance, tking, but what do you mean by a "3d Line"? It seems when I make that top surface my workplane, the line appears to be parallel with the workplane. Is there another way to do this create a line without going into another workplane?
Excuse my ignorance, tking, but what do you mean by a "3d Line"? It seems when I make that top surface my workplane, the line appears to be parallel with the workplane. Is there another way to do this create a line without going into another workplane?