How to edit hole size in position callout

Hello,

I am struggling to figure this out and I feel it should be simple.

So I measure the hole, hole size measures a couple thou larger than it actually is, how can I input a hole size verified with a pin gage in my report out?

Thanks

Parents

thecoot over 9 years ago

I usually put a comment at the top of the report (we use stepahead for generating reports) stating hole sizes are in spec with pin gage and or caliper

You could also use "keyin" for actual size if you like or put in either a Report Comment using input or Yes/No.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

thecoot over 9 years ago

I usually put a comment at the top of the report (we use stepahead for generating reports) stating hole sizes are in spec with pin gage and or caliper

You could also use "keyin" for actual size if you like or put in either a Report Comment using input or Yes/No.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data