How to edit hole size in position callout

Hello,

I am struggling to figure this out and I feel it should be simple.

So I measure the hole, hole size measures a couple thou larger than it actually is, how can I input a hole size verified with a pin gage in my report out?

Thanks

Parents

jeregonn over 9 years ago

Without the correct hole size in the position on the report the bonus is going to be off. If there is no way to edit the hole size to what it actually is I guess I can hide the Ø callout since it is rarely accurate and do as you said.

One other question I have is when entering [Ø.014(MMC)|A|B(MMC)] it asks for Ø___ after B. What is the correct thing to enter here? I have been entering the minimum hole size for B.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

jeregonn over 9 years ago

Without the correct hole size in the position on the report the bonus is going to be off. If there is no way to edit the hole size to what it actually is I guess I can hide the Ø callout since it is rarely accurate and do as you said.

One other question I have is when entering [Ø.014(MMC)|A|B(MMC)] it asks for Ø___ after B. What is the correct thing to enter here? I have been entering the minimum hole size for B.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data