I am struggling to figure this out and I feel it should be simple.
So I measure the hole, hole size measures a couple thou larger than it actually is, how can I input a hole size verified with a pin gage in my report out?
In program code change the nominal diameter to desired size, move the cursor up or down fo PC-DMIS to recognize the change, say YES when asked should you change measured value, change the diameter back to nominal, move the cursor up or down fo PC-DMIS to recognize the change, say NO when asked should you change measured value.
In program code change the nominal diameter to desired size, move the cursor up or down fo PC-DMIS to recognize the change, say YES when asked should you change measured value, change the diameter back to nominal, move the cursor up or down fo PC-DMIS to recognize the change, say NO when asked should you change measured value.