I am struggling to figure this out and I feel it should be simple.
So I measure the hole, hole size measures a couple thou larger than it actually is, how can I input a hole size verified with a pin gage in my report out?
That worked; however, when I ran the next it updated to the measured values. Do you know a way to prevent the new hole size I entered from being overwritten? I am in a sheet metal fab shop and some of these parts have a lot of holes. This process would add hours to some runs.
That worked; however, when I ran the next it updated to the measured values. Do you know a way to prevent the new hole size I entered from being overwritten? I am in a sheet metal fab shop and some of these parts have a lot of holes. This process would add hours to some runs.